3M™ VHB™ Structural Glazing Tape Project Initiation Form 1.1

Please fill out all required fields to initiate a project Application Review by 3M and PVD.

Note: Customer assumes responsibility for meeting all applicable building codes and requirements.

Customer Information

Customer*

Request Date*

Distributor*

Distributor Representative

How did you become aware of 3M™ VHB™ Structural Glazing Tape?
If other please specify below:

If other, please specify here:

Street Address*

City*

State*

Zip Code*

Customer Contact*

Customer Contact Title

Customer Contact Phone*
(xxx-xxx-xxxx)

Customer Contact Cell

Customer Contact Email*

Fabrication Information

Customer Fabrication*
Is this project being fabricated in-house at the location listed above? If no, provide the location of application of VHB™ SGT.

Yes No

Fabrication Start Date

Fabricator Name
If different than Customer

Street Address
Note: Actual place of VHB™ SGT bonding

City
Note: Actual place of VHB™ SGT bonding

State
Note: Actual place of VHB™ SGT bonding

Zip Code
Note: Actual place of VHB™ SGT bonding

Project Information

Project Name*
As described in Contract Documents

Street Address*

City*

Project State

Zip Code*

General Contractor*

Glazing Consultant

Architectural Firm*

Project Files
Upload Shop Drawings, and other pertinent documents such as specification sections, glazing and finish schedules

File Attachments
If files are larger than 29 MB, please upload from cloud based storage such as One Drive, Box, Dropbox, etc.

Project-Specific Design Parameters

Building Height*
Glazed area

Building Stories*
Number of floors

Windload Design Pressure Category*

ASCE 7-2005 ASCE 7-2010 IBC Other

If Other Design Category

Typical Zone PSF*

Corner Zone PSF

Aluminum Framing System and Glazing Infills

Glazing System*
List the system type and model

Other Finish
Identify type and specification

Sloped Glazing*
Glass sloping outward requires minimum two sides of support or other forms of positive hold and approval

Yes No

Vision Glass: Insulating Glass Unit (IGU)*

Yes No

Vision Glass: Laminated IGU*

Yes No

Vision Glass: Monolithic*

Yes No

Vision Glass: Laminated*

Yes No

Spandrel Glass: IGU*

Yes No

Spandrel Glass: Monolithic*

Yes No

Bonding Surface Spandrel Coating*
Note: VHB™ SGT develops high bond strength to most ceramic frit coatings. If Opacicoat is used, it requires masking off the bond area of the glass perimeter prior to application without contamination underneath it.

Metal Panel
List type of panel i.e. ACM or Insulating and description of bonding surface finish

Other Glazing Infill

Longest Glazing Infill Short Edge in Inches*
For the entire project: the longest short-edge dimension of infill panel per the aspect ratio e.g. 48" x 96" = 48" or 60" x 48" = 48"

Largest Infill Size W" x H"*
Largest single piece of glass or panel with the greatest area

Total Square Footage VHB™ SGT Glazing Area*

VHB™ Structural Glazing Tape

VHB™ SGT Type*

B23F Black G23F Grey

VHB™ SGT Width*
Note: Specific to system application. Not suitable for widths less than 5/8" without advanced 3M™ approval

Total Project LF Tape*
Estimated lineal footage of the entire project for systems that use VHB™ SGT